MIMAKI CJV330-160 - Function Setting Menu

Chapter 6 Settings
146
6.3 Function Setting Menu
This is used to set various operations to ensure optimal machine performance.
l
Menu List
Item
Setting
*1
Details
Heater - Set the heater temperature.
PRE OFF/20 to 60
°C
Preheats the media before printing to suppress rapid
temperature change.
PRINT OFF/20 to 50
°C
Helps prevent ink bleeding.
POST OFF/20 to 60
°C
Allows ink to dry after printing.
Off Time None / 0 to 90
min
Sets the time before turning the heater off after printing.
Logical Seek Host/OFF/ON Sets the range of carriage movement.
• OFF: Machine size area
Unidirectional print Bi-directional print
Carriage movement
• ON: Print data area
Unidirectional print Bi-directional print
Print data
Carriage movement
Take-up Unit - Sets the take-up unit operation.
Take-up Unit ON/OFF Set to "OFF" if the take-up unit is not used.
Take-up SW Continuous/
Temporary
Sets the function performed by the ON/OFF button on the take-
up unit in LOCAL mode.
• Continuous: Press the button to start/stop the take-up unit.
• Temporary: The take-up unit operates only while the button
is pressed. The unit stops when the button is released.
Drying Time - Sets the time for ink to dry.
Scan Host/0.0 to 9.9
sec
Sets the stop time of the carriage after each scan.
• The MIMAKI RIP software (RasterLink) indicates this as
"Pause Time per Scan".
Print End Host/0 to 120
min
Sets the stop time after printing. The next data is printed once
the set time has elapsed.