Chapter 6 Settings
141
Item Setting Details
*1 *2
Smoothing
Level (Color)
0 to 100 % - Increasing smoothing makes streaks less visible. Make
separate settings for color and spot color (white).
Smoothing
Level (Spot)
Media Information - - Enter the media information.
Media Type - - Select the media type to be used. The available media types
vary depending on the model.
Media Operation
Form
* CJV only
Roll/Leaf - Select whether roll media or leaf media is used.
Media Width AUTO/
MANUAL
- • AUTO: The media width is automatically detected with the
sensor.
• MANUAL: Press to set the media width manually.
– When media cannot be detected using AUTO, set to
"MANUAL".
Media Remain
Manage
ON/OFF - The remaining roll media amount can be displayed and printed
out in REMOTE mode. The print length will be displayed when
leaf media is in use.
• ON: An input screen appears once the media width is
detected. Press to set the media length.
Press the [FUNC3] key on the "Origin Setup" screen to
print the date and remaining media amount.
• OFF: The remaining media amount is not displayed.
Length 0 to 500 m - Enter the roll media length.
Detail Setting - -
Vacuum Fan Host/Weak/
Standard/
Strong
Stro
ng
Sets the force with which the medium is held down.
• This can be used to prevent media jamming and print
head damage caused by the media lifting up.
Feed Speed Host/10 to
100 to 200 %
100 Sets the media feed speed.
• Depending on print conditions, the speed may not vary for
certain settings.
• Setting to 100 % or more reduces the time required to
complete printing but may affect print quality due to
insufficient drying time.
Clamp Pressure
*JV/TS only
AUTO/Weak/
Standard/
Strong
- Sets the clamp pressure.
Pre Feed
*TS only
OFF
/100
to
500
mm
Sets the distance the media is fed backward and forward
before printing.
• Moving the media backward and forward prevents it
sticking to the platen and minimizes wrinkles in the media.
Media Name
Change
- - You can change the name of a setting type. The name can
include alphanumeric characters or symbols.
Delete MediaInfo - - Delete the set media information.
*1. The default settings are shown underlined.
*2. Settings applied if no settings can be made in the RIP software (host) or if this machine is prioritized.
6
To Next Page
Loading...
