1-8
Accessories
Select the accessories according to the type of work or engraving.
*1
For information on how to attach them, see the reference page of each tool.
*1. Refer to the Cutting Condition Table. ( P.6-6)
Name Application Illustration
Cutter It is used for engraving. P.1-9
Chip Removal Attach-
ment
It vacuums dust during engraving.
It is used when the cutter is used.
Two types of the opening diameter,
φ26mm and φ11mm, are available.
P. 1 -11
Vacuum Hose It is used for connecting the chip
removal attachment and the
cleaner.
P.1-12
Hose clip Fix the chip removal attachment. P.1-12
To Next Page
Loading...
