How to Turn On/Off the Spindle
2-7
How to Turn On/Off the Spindle
How to turn on/off the rotation of the spindle
Rotate the spindle before starting engraving.
Pressing key rotates the spindle. Another press will stop the spindle.
How to adjust the rotating speed of the spindle
Adjust the rotating speed of the spindle using the adjusting knob ( P.1-4) located on the right in the
front of the machine.
Keep your hands or head away from the head while the spindle is rotating.
While the spindle is rotating, keep your hands or head away from the head. It could catch hair or
a sleeve, or the rotating blade could injure hands.
While the spindle is rotating, keep away from this machine 30 cm or more except when stopping
in an emergency or operating the panel.
Automatic spindle rotation on/off
In the following cases, this machine automatically turns the spindle rotation on/off.
(1) When any data is received in the remote mode, the spindle automatically rotates.
(2) After this machine has stopped for about three seconds in the remote mode, the spindle rota-
tion automatically stops.
(3) When Test Cut or Self Test (engraving a logo) is performed, the spindle automatically rotates.
O
To Next Page
Loading...
