MIMAKI ME-300STII - Error Messages and Solutions

5-2
Error Messages and Solutions
Error message Cause
Solution
ERROR C02
MAIN RAM
Trouble has occurred in the control
RAM.
Contact your dealer or a sales
office of MIMAKI.
ERROR C04
EEPROM
Trouble has occurred in the system
ROM.
ERROR C10
COMMAND
Code other than command data
has been received.
Make the command setting
consistent with the setting on
the host computer side.
(P.4-7)
If a G-code is set, check its
settings for the G-code setting
items.
( P.4-10)
ERROR C11
PARAMETER
A parameter outside the numerical
range has been received.
Check the command setting on
the host computer.
The point specified by G-code
data went off the scale.
(P.4-7)
ERROR C12
DEVICE
The plotter received an improper
device control command.
ERROR C20
I/O
The communication condition is
different.
Make the communication
condition same as that of the
host computer side.
(
P. 4 -9 )
ERROR C27
BUFFER OVER
The interface is faulty.
Check the interface cable.
(
P. 4 -9 )
ERROR 901
OPERATION
An invalid operation was
performed on the control panel.
Refer to the relevant page of
operation manual for valid
operations.
ERROR C31
NO DATA
The plotter started the plural
sheets cutting but found that there
is no data in the receiver buffer.
Refer to the explanation of the
plural sheets cutting function.
(
P. 4 -3 )
ERROR C32
DATAtooBIG
Received data is too large, it is not
possible to cut the number of
copies
ERROR 902
DAT REMAIN
The plotter executed an improper
operation during a halt.
Press the key to cut the
remaining data or execute data
clear if there is no need of using
the data in the receiver
buffer.(
P. 4 -2 )
ERROR 401
MOTOR X
An excessive load was applied to
the head driving motor.
Turn the power off once and turn
it on again.
If the same error message still
appears, contact your distributor
or a sales office of MIMAKI.
ERROR 402
MOTOR Y
An excessive load was applied to
the table driving motor.
ERROR 403
X CURRENT
An overcurrent error in the motor in
the head driving motor.
ERROR 404
Y CURRENT
An overcurrent error in the motor in
the table driving motor.