1-11
Mounting Tools
How to mount the chip removal attachment
1
Insert the flange of the chip removal attach-
ment into the slot of the holder.
Push it until it contacts the sensor.
2
Turn the knob to tighten it.
Turn the power of this machine off when mounting tools.
If the spindle rotates during mounting the tools, it could cause injury including fracture of fingers
or hands, avulsion of nails, or burn.
Before mounting the tools, turn the power of this machine off.
Mount the tools firmly.
Mount the tools properly and firmly following the instruction of this manual.
If not mounted firmly, engraving accuracy may reduce, or the tools may come off and cause an
injury.
To Next Page
Loading...
