3-6
How to Set X / Y Axis Origin
The X / Y axis origin (It is also called origin.) is the start point of engraving.
This machine engraves as the figure below
*1
with reference to an origin.
1
Move the head to the target position with
.
2
Press to set.
The origin set here is saved after the power is turned
on again.
How to clear
To clear the set origin to return to the lower-left corner press .
*1. When MIMAKI logo is engraved at the self test. ( P.4-6)
• If a G-code is set using an operation switch, set the origin using the G Work Origin Menu.
(
P.4-12)
• The moving speed increases while
the is also held.
• When you press the , you
can change the transfer unit of X-axis
and Y-axis. (
0.1mm0.01mm)
• If you attempt to set the origin
outside of the cut area, an error
message (ERROR 901 OPERATION)
will appear on the LCD.
To Next Page
Loading...
