MIMAKI ME-300STII - Page 41

90 pages

To Next Page

To Previous Page

How to Set the Work

3-5

For a work larger than the table, remove the reference scale and attach with a double-sided

adhesive tape.

Main Page

Default Chapter2
- Foreword2
  - For Safe Operation2
  - Requests3
- Before Use4
- Position of the Warning Labels7
- Definition of Term8
- Table of Contents9
Chapter 1 Preparation13
Confirming Accessories14
Part Names and Functions16
Choosing the Installation Site18
Connecting the Cables19
- How to Connect the Power Cable (Machine Side) / USB Cable / Operation Panel Cable / Interface Cable19
Accessories20
Mounting Tools21
- How to Mount the Cutter and the Endmill21
- How to Mount the Chip Removal Attachment23
- How to Mount the Vacuum Hose24
Chapter 2 Preparatory Operations25
Operation Panel26
How to Turn on /Off the Power28
- Initial Action28
- How to Stop the Machine in an Emergency29
How to Turn On/Off the Spindle31
- How to Turn On/Off the Rotation of the Spindle31
- How to Adjust the Rotating Speed of the Spindle31
Operation Modes32
- How to Change the Operation Mode32
- Local Mode33
- Remote Mode35
- Pause Mode36
Chapter 3 Basic Operations37
Operation Flow38
How to Set the Work39
- Clamping the Work with the Clamp Tools40
- Attaching the Work with a Double-Sided Adhesive Tape40
How to Set X / y Axis Origin42
- How to Clear42
How to Set Cutting Area43
How to Set Z Axis Reference Point44
- When the Auto Flat Detection Switch Is off (Manual Setting)44
- When the Auto Flat Detection Switch Is off (Automatic Setting)45
- When the Auto Flat Detection Switch Is on or AUTO45
How to Set Flatness Correction Amount46
- Flatness Correction Amount46
- How to Choose the Auto Flat Detection Switch46
- How to Set47
How to Set Cutting Depth / Lifting Amount in Z Axis48
- Lifting Amount49
How to Set Cutting Conditions50
- Error Messages Related to the Cutting Conditions51
How to Test-Cut52
How to Send Data from the Host53
Daily Care54
- Cleaning this Machine and Surroundings54
Chapter 4 Advance Operation and Adjustments55
How to Clear Data56
How to Copy57
- Relation between Overwriting of Received Data and Copying58
How to Move the Head out of Engraving Area59
How to Perform Self Test60
How to Set the Mode Switch61
How to Set Communication Conditions63
Setting G-Code Items64
Registering an Origin for the G-Code Work Coordinates System66
- To Clear the Registered Origin67
Chapter 5 Errors and Solutions69
Error Messages and Solutions70
Other Error Messages72
Troubleshooting74
- Power Is Not Turned on74
- The Cutter Is Not Lowered74
- The Spindle Does Not Rotate74
- The Machine Does Not Engrave Finely75
Chapter 6 Appendix77
How to Install the Cutter78
How to Replace the Motor Brush79
Cutting Condition Table82
- Engraving82
- Forming Cut out Letters82
- Modeling83
Supplied Items84
- Supplied Items and Optional Items84
- Starter Kit85

MIMAKI ME-300STII - Page 41

Table of Contents

Related product manuals