MIMAKI ME-300STII - How to Move the Head out of Engraving Area

How to Move the Head out of Engraving Area
4-5
How to Move the Head out of Engraving
Area
The head is moved to the back left of the clamp table in the following procedures.
If the cutter is lowered, the head will move after lifting the cutter.
1
Press (or ) to display
the second page of the local mode.
2
Press (or ) to display
the screen shown on the right.
3
Press to start to move the head.
*1
*1. Press on the step 3 to cancel moving of the head.
[LCL]Spin-OFF2/4
Single Copy -->
View -->
Cu t A r ea - - >
F2
<V i ew>
END k e y t o s t a r t
CE key t o cance l