1-9
Mounting Tools
Mounting Tools
How to mount the cutter and the endmill
1
Insert the cutter into the spindle.
2
Turn the cutter manually to the direction of
the arrow.
Turn the power of this machine off when mounting tools.
If the spindle rotates during mounting the tools, it could cause injury including fracture of fingers
or hands, avulsion of nails, or burn.
Before mounting the tools, turn the power of this machine off.
Attention to the cutting edge of cutting blade
Caution to the cutting edge of the cutter during tool exchange.
The cutter blade is very sharp. There is a risk of injury such as cutting a finger.
Mount the tools firmly.
Mount the tools properly and firmly following the instruction of this manual.
If not mounted firmly, engraving accuracy may reduce, or the tools may come off and cause an
injury.
To Next Page
Loading...
