4
Before Use
Do not touch the head and the X bar at work.
W h i l e t h i s m a c h i n e i s i n o p e r a t i o n o r w a i t i n g f o r
data, do not touch the head and the X bar.
If touched, fingers will be pinched between the
X bar slot and the head and cut.
Keep away from this machine 30 cm or more at
work except when stopping in an emergency or
operating the panel.
Do not touch the table except the operation panel and the emergency switch at work.
W h i l e t h i s m a c h i n e i s i n o p e r a t i o n o r w a i t i n g f o r
data, do not touch the table.
If touched, you could suffer abrasions on the
moving table.
Keep away from this machine 30 cm or more at
work except when stopping in an emergency or
operating the panel.
Keep your hands or head away from the head
while the spindle is rotating.
While the spindle is rotating, keep your hands
or head away from the head. It could catch hair
or a sleeve, or the rotating blade could injure
hands.
While the spindle is rotating, keep away from
this machine 30 cm or more except when
stopping in an emergency or operating the
panel.
Do not touch carelessly to the cutter blade
The cutter blade is very sharp. There is a risk of injury such as cutting a finger.
To Next Page
Loading...
