2-12
Pause mode
Press key while the machine is engraving to enter the pause mode.
(If the cutter is moving, the machine stops immediately.)
*1*2*3*4*5
Press key under the pause mode to continue engraving.
Press key to return to the local mode.
*1. During the pause mode, spindle stops. When it resume, will rotates the spindle again.
*2. The location of the Z axis in the pose mode can be set by a pose of Operation switch.
*3. While the flat detection is in operation (When the auto flat detection switch is ON or AUTO ( P.3-9)), the
machine does not stop until the operation is completed.
*4. While the flatness follow-up function is active (the auto flat detection operation switch is set to AUTO), the
machine may not stop immediately.
*5. hen moving to the local mode after pressing , if "Please wait" is being displayed, even by pressing
, you cannot stop the machine immediately.
To Next Page
Loading...
