MIMAKI ME-300STII - Local Mode

Operation Modes
2-9
Local mode
When the power is turned on, the machine will perform the initial action, then will go to the local mode.
Engraving and cutting conditions can be set in this mode. All the keys on the operation panel are oper-
ative.
There are three LCD displays in this mode, type A, B, C.
The operation items available under the local mode are listed in the table below.
No. Display Description
(1) [Local] Indicates that the machine is now in the local mode.
(2) * / * A)
B)
A) Indicates the total number of pages.
B) Indicates the current page number. Press or
key to change the number.
(3) Mode Switch
Self Test
Interface
Indicates the items that can be operated.
(4) <XXXXXXXXX> Indicates the operation items.
*1
*1.For details of the items, see the next page.
(5) Baud Rate
Data Bits
Parity
Indicates the set item.
(6) END key to Start Press key to execute test or others.
(7) CE key to cancel Press to cancel test or others.
[LCL]Spin-OFF3/4
Mo d e Sw i t c h - - >
Se l f Tes t - - >
Interface -->
(1)
{
(3)
Type A
<RS- 232C> 1 / 2
Baud Ra t e *9600>
Da t a B i t s * 8>
Pa r i t y *EVEN>
(4)
{
(5)
Type B
(2)
<Tes t Cu t >
END k e y t o s t a r t
CE k e y t o c a n c e l
(4)
(6)
Type C
(7)
(2)