3-2
Operation Flow
The basic engraving procedure is as follows.
This chapter describes the operations after the tool is set and the power is turned on. For information
on how to attach tools or how to turn the power on, see the previous chapter.
1. Attach the tools.
"Mounting Tools" (P.1-9)
2. Turn the power on.
"How to Turn On /Off the Power" (P.2-4)
3. Set the work.
"How to Set the Work" (P.3-3)
4. Set X / Y origin.
"How to Set X / Y Axis Origin" (P.3-6)
5. Set the cutting area.
"How to Set Cutting Area" (P.3-7)
When auto flat detection switch is OFF When auto flat detection switch is ON or AUTO
6. Set Z axis reference point. 6. Set flatness correction amount.
"How to Set Z Axis Reference Point" (P.3-8) "How to Set Flatness Correction Amount" (P.3-10)
7. Set cutting depth / lifting amount of the cutter.
"How to Set Cutting Depth / Lifting Amount in Z Axis" (P.3-12)
8. Set cutting conditions.
"How to Set Cutting Conditions" (P.3-14)
9. Test the cutting conditions.
"How to Test-Cut" (P.3-16)
10. Send data from the host (engraving).
"How to Send Data from the Host" (P.3-17)
11. Turn the power off.
"How to Turn On /Off the Power" (P.2-4)
12. Clean the machine or surroundings.
"Daily Care" (P.3-18)
To Next Page
Loading...
