MIMAKI ME-300STII - Operation Modes; How to Change the Operation Mode

2-8
Operation Modes
How to change the operation mode
This machine is operated under the major three different operation modes.
Various conditions can be set in this mode before engraving.
Every time the power is turned on, the machine will enter this mode.
All the keys on the operation panel are operative.
The machine engraves or waits for data to be transmitted from the
host under this mode.
Only keys are operative.
The machine temporarily stops engraving.
Power on
Initial action
Local Mode
Remote
Pause
[LCL]Spin.OFF1/4
Cond i t i on - ->
Tes t Cu t - ->
Da t a C l ea r - - >
[Remote] 1KB
Sp i n .ON Com. IIC
ZD : 1 . 00 Z - ES : 10
ZC : 2 . 00 XYES : 4 0
[Pause]
END Ke y t o CONT .
CE Ke y t o Re s e t