6-2
How to Install the Cutter
Install the cutter blade to the cutter holder as follows.
1
Insert a cutter blade or an endmill into the
holder.
Insert it to the end.
2
Put the hexagon wrench (1.5 mm) in the
hole of the holder, and turn to the direction
of the arrow to tighten it.
Handle the cutter blade with care.
The tip of the cutter blade is so sharp that could cut fingers.
If the cutter blade is dropped down, the tip of the blade will be chipped and worsen the engraving
quality.
Handle the cutter blade with care.
To Next Page
Loading...
