What to do if the cutter is not lowered on my MIMAKI ME-300STII Plotter?
If the cutter on your MIMAKI Plotter is not lowering, try setting the Z axis reference point. Also, ensure that the vacuum hose is mounted in a way that it does not pull up the cutter.
What to do if my MIMAKI ME-300STII Plotter does not engrave finely?
If your MIMAKI Plotter is not engraving finely, ensure the work is firmly fixed on the clamp table and the chip removal attachment is securely mounted. Also, check that the suction power of the cleaner is sufficient and that the vacuum hose isn't pulling up the material. Verify the cutting depth is properly set and the cutting condition is appropriate for the material being used. Consider replacing the cutter with a new one.
Why does the spindle not rotate on my MIMAKI Plotter?
If the spindle on your MIMAKI Plotter is not rotating, first ensure that the spindle rotation is set to ON before sending any data. Also, make sure that you have released the command following the operation manual of the host computer. Check that the SPINDLE of the operation switch is not set to OFF.
Provides instructions for safe operation and risk avoidance.
Explains the meaning of warning and caution symbols used in the manual.
Details required attire and workplace safety rules for operation.
Guidelines for understanding the manual and making inquiries.
Procedure to verify all included accessories upon unpacking.
Identifies and explains the machine's components and their roles.
Guidelines for selecting an appropriate installation location for the machine.
Instructions for connecting power, USB, and interface cables.
Step-by-step guide for attaching cutting tools and attachments.
Details the components and functions of the machine's operation panel.
Steps for safely powering the machine on and off.
Instructions for immediately stopping the machine in an emergency.
How to turn the spindle rotation on/off and adjust its speed.
Procedures for clearing, copying, and managing data in the receive buffer.
Moving the head, performing self-tests, and setting operational modes.
Setting communication conditions and configuring G-code parameters.
Lists common error messages, their causes, and initial troubleshooting steps.
Guides for resolving specific operational problems like power or spindle issues.
Steps for installing cutters and replacing motor brushes.
Provides recommended settings for engraving various materials.
Lists included accessories and available optional items for the machine.
To Next Page
General