10
Operation Modes................................................................................................ 2-8
How to change the operation mode......................................................................................2-8
Local mode ........................................................................................................................... 2-9
Remote mode ..................................................................................................................... 2-11
Pause mode........................................................................................................................ 2-12
CHAPTER 3 BASIC OPERATIONS
Operation Flow ................................................................................................... 3-2
How to Set the Work .......................................................................................... 3-3
Clamping the work with the clamp tools ...............................................................................3-4
Attaching the work with a double-sided adhesive tape......................................................... 3-4
How to Set X / Y Axis Origin.............................................................................. 3-6
How to clear.......................................................................................................................... 3-6
How to Set Cutting Area .................................................................................... 3-7
How to Set Z Axis Reference Point .................................................................. 3-8
When the auto flat detection switch is OFF (manual setting) ............................................... 3-8
When the auto flat detection switch is OFF (automatic setting)............................................ 3-9
When the auto flat detection switch is ON or AUTO............................................................. 3-9
How to Set Flatness Correction Amount ....................................................... 3-10
Flatness Correction Amount ............................................................................................... 3-10
How to choose the auto flat detection switch...................................................................... 3-10
How to set........................................................................................................................... 3-11
How to Set Cutting Depth / Lifting Amount in Z Axis ................................... 3-12
Lifting amount ..................................................................................................................... 3-13
How to Set Cutting Conditions ....................................................................... 3-14
Error messages related to the cutting conditions................................................................ 3-15
How to Test-Cut ................................................................................................ 3-16
How to Send Data from the Host .................................................................... 3-17
Daily Care.......................................................................................................... 3-18
Cleaning this machine and surroundings............................................................................ 3-18
To Next Page
Loading...
