MIMAKI ME-300STII - Chapter 4 Advance Operation and Adjustments; Data Management and Operations; Machine Operation and Testing; Communication and G-code Configuration

11
CHAPTER 4 ADVANCE OPERATION AND ADJUSTMENTS
How to Clear Data ...............................................................................................4-2
How to Copy........................................................................................................4-3
Relation between overwriting of received data and copying................................................. 4-4
How to Move the Head out of Engraving Area.................................................4-5
How to Perform Self Test ................................................................................... 4-6
How to Set the Mode Switch.............................................................................. 4-7
How to Set Communication Conditions ...........................................................4-9
Setting G-code Items........................................................................................4-10
Registering an Origin for the G-code Work Coordinates System................4-12
To clear the registered origin .............................................................................................. 4-13
CHAPTER 5 ERRORS AND SOLUTIONS
Error Messages and Solutions ..........................................................................5-2
Other Error Messages ........................................................................................5-4
Troubleshooting.................................................................................................. 5-6
Power is not turned on.......................................................................................................... 5-6
The cutter is not lowered. .....................................................................................................5-6
The spindle does not rotate. ................................................................................................. 5-6
The machine does not engrave finely. .................................................................................. 5-7
CHAPTER 6 APPENDIX
How to Install the Cutter ....................................................................................6-2
How to Replace the Motor Brush ......................................................................6-3
Cutting Condition Table ..................................................................................... 6-6
Engraving.............................................................................................................................. 6-6
Forming cut out letters .......................................................................................................... 6-6
Modeling ............................................................................................................................... 6-7
Supplied items ....................................................................................................6-8
Supplied items and optional items ........................................................................................ 6-8
Starter kit............................................................................................................................... 6-9