Cutting Condition Table
6-7
Modeling
Material Tool
Cutting
depth
(mm)
Rotating
speed
(rpm)
Feed
speed
(mm/s)
Remarks
ABS Ball endmill
(f2)
2 10000 XY:20 Z:10 1)If the spindle rotating speed is too
high, chippings may remain and
make the appearance bad.
2)In general, the quality of the cut sur-
face differs depending on whether to
cut downward or upward.
3)If the cutting depth is too small, the
cutting quality may become bad.
4)The conditions differ between side-
face cutting and groove machining.
To Next Page
Loading...
