MIMAKI ME-300STII - How to Clear Data

4-2
How to Clear Data
Data stored in the receive buffer is cleared in the following procedures.
*1
1
Press (or ) to display
the first page of the local mode.
2
Press (or ) to display
the screen shown on the right.
3
Press to clear data in the buffer.
*2
*1. Even after clearing data, the data sent before can be used to engrave again by copying.
If new data is sent, the data sent before clearing the data cannot be used. (The old data is erased with the
new data.)
*2. Press on the step 3 to cancel clearing of the data.
[LCL]Spin-OFF1/4
Cond i t i on - ->
Tes t Cu t - - >
Da t a C l ea r - - >
F3
<Da t a C l ea r >
END k e y t o s t a r t
CE key to cance l