Troubleshooting
5-7
The machine does not engrave finely.
Trou-
ble
Engraved line width is unequal.
Check Point Solution
1. Is the work fixed on the clamp table firmly?
Fix the work firmly on the clamp table.
P.3-3
2. Is the chip removal attachment mounted firmly?
Mount the chip removal attachment firmly.
P.1-11
3. Is dust and chips surely vacuumed?
Check the suction power of the cleaner does not
decrease.
4.Is the vacuum hose pulling up the chip removal
attachment?
Mount it in order not the vacuum hose to pull up.
P.1-12
5. Is cutting depth too shallow?
Set the cutting depth properly.
P.3-12
6. Is there burr?
Check the cutting condition meets the material of
the work used.
P.3-14
Replace it with a new cutter.
P.6-2
7. Is the rack for this machine loosened?
Put this machine on the fast rack.
To Next Page
Loading...
