Operation Panel
2-3
No.
Name
Indication
in this manual
Function
1 Power Indicator Lamp POWER lamp Lights up when the power is turned on.
2 LCD Display Gives information required for operation to the
operator. (16 columns x 4 lines)
3 REMOTE/LOCAL Key Changes the operation mode between the
remote and the local or stops the operation
temporarily.
4 SPINDLE ON/OFF Key Switches ON/OFF of the spindle.
5 SPINDLE
POSITION UP/DOWN
Key
Specifies the lifting amount and cutting depth
of the cutter.
6 X/Y Coordinates Move
Key
Moves the X/Y coordinates.
: Moves the head to the left.
: Moves the head to the right.
: Moves the clamp table to the back.
: Moves the clamp table to the front.
7 Z Axis Move Key
Moves the cutter on Z axis.
: Raises the head.
: Lowers the head.
8 Origin Set Key (XY) Specifies the X/Y axis origin.
Origin Set Key (Z) Specifies the Z axis origin.
9 Page (±) Key Changes the page shown on the LCD.
10 Function Key Selects an operation item (set value).
11 Cancel Key Interrupts the operation.
12 End Key Terminates the operation (with data set or cut-
ting to be executed).
13 Pause Key Suspends the machine instantaneously.
To Next Page
Loading...
