6
Do not shake this machine heavily.
Do not shake this machine heavily to prevent breakdown of this p r e c i s i o n m e c h a n i c a l
equipment.
If shaken, cutting accuracy may reduce or the electric parts may be broken.
This machine must be carried by two or three people.
Handling of water or oil
Do not put water or oil on this machine. They may break precision parts or may cause an electric
shock. In such a case, turn the power off immediately, and contact a distributor in your district.
Cleaning precautions
Do not use a spray including air gun to clean waste.
If used, waste may get into the precision part and may cause breakdown.
Vacuum up waste with a cleaner.
Mount the work and the tools firmly.
Mount the work and the tools properly and firmly following the instruction of this manual.
If not mounted firmly, engraving accuracy may reduce, the table m a y b e s c r a t c h e d , o r t h e w o r k
or the tools may come off and cause an injury.
Ventilate well.
When using harmful works to humans, ventilate the room well. For e x a m p l e , c u t t i n g P V C b o a r d
in an improper cutting condition may generate a great amount of harmful gas.
Do not cut in an improper cutting condition.
If cutting in an improper cutting condition, the cutter may break, pop up, and cause an injury.
Cutting precautions
Wear goggles when cutting works. The operator must inform the person unrelated to this
machine of risk of this machine or keep the person away from this machine.
A broken blade may injure the person.
CAD or data precautions
Please note that a breakdown of CAD or problems of data may cause an unexpected motion.
Cap the port after using.
The service power connecting port is located on the rear panel of this machine (see P.1-5).
Cap it when not in use or after using. If not capped, it may cause an electric shock.
To Next Page
Loading...
