4-8
1
Press (or ) to display
the third page of the local mode.
2
Press (or ) to display
the screen shown on the right.
Press the function key to set the values of Auto View,
Flatness, and Command.
3
Press to display shown on the
right.
Press the function key to set the values of Unit, Spin-
dle, and OH unit.
4
Press to display the screen
shown on the right.
Press the function key to set the ORIGIN, the value for
Z direction, Tool-up selection at the time of pause.
5
Press to fix the setting.
*1
OH response value is valid only
when the command is IIc, and is not
valid for Ic1 and G code.
Origin • Z direction is valid only
when the command is IIc. It is not
valid for Ic1 and G code.
*1. Press on the step 5 to cancel the setting.
To Next Page
Loading...
