6-12
Supported G-code List
The following table is a list of G-codes supported by this machine.
G-code is compatible with firmware version 1.40 or later.
G20 (Input in inches) and G21 (Input in mm) are not valid as a command. Those units are automati-
cally set referring the setting for coordinate indication unit to an operation switch in the operation panel
menu.
No. G code Function
1 G00 Positioning
2 G01 Linear interpolation
3 G02 Circular arc interpolation CW
4 G03 Circular arc interpolation CCW
5 G04 Dwell
6 G10 Work coordinates system offset
7 G17 XY plane specification
8 G54 Work coordinates system 1 selection
9 G55 Work coordinates system 2 selection
10 G56 Work coordinates system 3 selection
11 G57 Work coordinates system 4 selection
12 G58 Work coordinates system 5 selection
13 G59 Work coordinates system 6 selection
14 G80 Fixed cycle cancellation
15 G81 Hole drilling cycle
16 G82 Hole drilling cycle (With dwell)
17 G83 Deep hole drilling cycle
18 G90 Absolute input
19 G91 Incremental input
20 G92 Coordinates system setting
21 G98 Initial level restoration
22 G99 R-point level restoration
23 M00 Program stop
24 M02 End of program
25 M03 Spindle normal rotation
26 M05 Spindle stop
27 M08 Coolant ON
28 M09 Coolant OFF
29 M30 Program end
30 F Feed speed
31 % Program start
32 () Note section
To Next Page
Loading...
