MIMAKI TS300P-1800 - Warning; Error Messages; Warning Messages

Chapter5 Troubleshooting
5-4
Warning / Error Messages
If some trouble occurs, the buzzer sounds and the display shows a corresponding error message.
Take an appropriate remedy for the displayed error.
Warning messages
Errors when performing operations
Message displayed in LOCAL
Message Cause Solution
Operation cannot be performed because
no media is detected.
• Execute after media is detected.
The motor is OFF after the cover was
opened etc.
• Return to LOCAL and execute the operation
after completion of initialization.
An ink error occurred.
• Execute the operation after replacing with a
new ink pack.
The front cover or the maintenance
cover is opened.
• Execute the operation after closing the
cover.
Data was received.
• Execute the operation after executing data
clear. ( P.2-19)
Message Cause Solution
Multiple ink errors (unusable ink) have
occurred, making it impossible to feed
ink (printing and cleaning, etc.).
Replace with a new ink pack.
The waste ink tank count has exceeded
the prescribed amount.
Check the amount of waste ink in the waste
ink tank.
Conduct maintenance and waste ink tank
replacement, and reset the amount of waste
ink.
The used count of wiper has exceeded
the prescribed number.
Execute maintenance, station maintenance
and wiper exchange and replace the wiper.
Displayed when power is forcibly turned
OFF and restarted after occurrence of
“ERROR 710 heater temp error”.
If the same error message appears again,
contact our service desk or your local distribu-
tor to call for service.
No media is set. Or, the sensor is faulty.
Set the media.
If the same error message still appears after
setting the media, contact our service desk or
your local distributor to call for service.
Print data is received in LOCAL.
Shift to REMOTE and execute printing.
Or, execute data clear and cancel printing.
Stable printing cannot be done because
temperature in the installed environment
(printer) is too high.
Adjust the ambient temperature to within the
specified scope (20°C to 35°C).
Stable printing cannot be done because
temperature in the installed environment
(printer) is too low.
INVAILD OPERATION
:MEDIA UNDETECT
INVAILD OPERATION
:MOTOR POWER OFF
INVAILD OPERATION
INK ERROR
INVAILD OPERATION
COVER OPEN
INVAILD OPERATION
DATA REMAIN
Can't print/cartridge
Check waste ink
Replace WIPER
HEATER Temp. error
Powered off
NO MEDIA
DATA REMAIN
MACHINE TEMP./H **°C
MACHINE TEMP./L **°C