MIMAKI TS300P-1800 - Chapter 4: Maintenance

This chapter
describes the items required to use this machine more comfortably, which are the
methods for the daily care, the maintenance of the ink cartridges etc.
Maintenance .................................................4-2
Precautions for Maintenance ...................... 4-2
About Cleaning Solution.............................. 4-2
Cleaning the Exterior Surfaces ................... 4-2
Cleaning the Platen ..................................... 4-2
Cleaning the Media Sensor ......................... 4-2
Cleaning the Media Press ........................... 4-3
About MAINTENANCE MENU ......................4-4
MAINTENANCE MENUs at-a-glance .......... 4-5
Maintaining the Capping Station ...................4-6
Cleaning the Wiper and Cap ....................... 4-6
Washing the Head Nozzle ........................... 4-7
Washing the Ink Discharge Passage .......... 4-9
When the Machine Is Not Used for a Long
Time ......................................................... 4-10
Cleaning the Ink Head and the Area
around It ......................................................4-12
Nozzle Recovery Function ..............................4-13
Reset the set value ....................................4-14
Check the condition for which nozzle
recovery cannot be performed ...................4-14
Enabling or disabling nozzle recovery
during a test print .......................................4-14
Automatic Maintenance Function ................4-15
Setting the Refreshing Intervals .................4-15
Setting the Tube Wash Intervals ................4-15
Setting the Cleaning Intervals and Type ....4-15
Suspend the nozzle cleaning .....................4-16
Fill up Ink .....................................................4-16
Replacing consumables ..............................4-16
Replacing the wiper ...................................4-16
If a Waste Ink Tank Confirmation
Message Appears ......................................4-17
Replace the waste ink tank with another ...4-18
Replacing the Cutter Blade ........................4-19
Chapter 4
Maintenance