This chapter
describes the various setting of this machine.
About SETUP MENU ....................................3-2
SETUP MENU table.................................... 3-3
Register the optimal print conditions to
match the use.............................................. 3-4
Setting of Media Correction......................... 3-5
If the Positions of Dots Shift... ..................... 3-6
Setting the HEATER ................................... 3-6
Setting the Optional heater ......................... 3-7
Setting of Logical Seek ............................... 3-7
Setting of Overprint ..................................... 3-8
Setting of Drying Time................................. 3-8
Setting of Left and Right Margins............... 3-8
Setting of VacuumFan................................. 3-9
Setting of Feed Speed ................................ 3-9
Setting of Feed Quality................................ 3-9
Setting of MAPS4...................................... 3-10
Setting Auto Cleaning ............................... 3-11
Setting Interval wiping ............................... 3-11
Setting Pre-feed ........................................ 3-12
About MACHINE SETUP MENU ................3-13
MACHINE SETUP MENU table ................ 3-14
Setting a AUTO Power-off......................... 3-16
Setting Take-up unit .................................. 3-16
Setting Top Blower.................................... 3-16
Setting the Display of Media Residual....... 3-17
Setting the PG Drop Adjust........................ 3-17
Setting the Media Detection....................... 3-17
Setting the Drying Feed............................. 3-18
Setting a LANGUAGE................................ 3-18
Setting Time............................................... 3-18
Setting Unit (Temperature/ Length) ........... 3-18
Setting a KEY BUZZER............................. 3-19
Setting the CONFIRM. FEED .................... 3-19
Setting the SPACE FEED MODE.............. 3-19
Set the network.......................................... 3-20
Setting event mail function......................... 3-20
Initializing the Settings............................... 3-24
About NOZZLE CHECK MENU ..................3-25
INFORMATION MENU table ..................... 3-25
Printing Check Flow................................... 3-26
Printing Operations at “Nozzle Missing”
Judgment and Error Occurrence ............... 3-26
Setting the Printing Check ......................... 3-27
Setting the NOZZLE RECOVERY ............. 3-27
Setting the Judgement Condition............... 3-27
About INFORMATION MENU .....................3-28
INFORMATION MENU table ..................... 3-28
Displaying the Information ......................... 3-29
Chapter 3
Setup
To Next Page
Loading...
