MIMAKI TS300P-1800 - If a Waste Ink Tank Confirmation Message Appears

4-17
1
2
2
4
5
6
Chapter 4 Maintenance
4
Press the key.
• The carriage will move onto the platen.
.
5
Remove the wiper.
• Pull out the wiper by holding the protrusions at its
both ends.
6
Insert a new wiper.
• Insert the wiper by holding the protrusions at its
both ends.
7
Close the front cover, and press the
key.
• After its initial operation, the machine returns to
LOCAL.
If a Waste Ink Tank Confirmation
Message Appears
Ink used in head cleaning, etc. is stored in the waste ink
tank on the lower right side of the machine.This machine
counts the accumulated amount of discharged ink. When
that reaches a specified amount, the machine displays a
confirmation message.(When this message is displayed,
consider the replacement of the waste ink tank.)
Confirmation Message in LOCAL
1
The warning message “Check waste ink”
is displayed.
2
Check the state of the waste ink tank
• For any difference between the displayed level
and the actual level of discharge amount, carry
out the operations described in and after step 3.
• If there is no difference between the displayed
level and the actual level, and if you replace
(dispose of) the waste ink tank, carry out the
procedure described in “Replace the waste ink
tank with another” ( P.4-18)
3
Press
(MENU)
in LOCAL.
• MAINTENANCE MENU will be displayed.
4
Press to select “INK TANK
EXCHANGE”, and press the key.
5
If the amount of waste ink needs to be
adjusted, press the key.
6
Press to adjust the level, and
press .
7
Press the key.
Carriage
Projection
Projection
• The message is displayed when it reaches 80%
(1.6L ) of the 2L tank.