MIMAKI TS300P-1800 - Suspend the Nozzle Cleaning; Fill up Ink; Replacing Consumables; Replacing the Wiper

4-16
Chapter 4 Maintenance
Suspend the nozzle cleaning
When you want to work as such a printing during the
nozzle cleaning, you can interrupt the nozzle cleaning.
1
Press the key during the
nozzle cleaning implement.
• Display the selection screen of the nozzle
cleaning stop.
2
Press to select “CANCEL”.
Fill up Ink
Supplies ink to correct nozzle clogging.
1
Press
(MENU)
in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press to select “FILL UP INK”,
and press the key.
3
Press to select the filling head,
and press the key.
4
Press the key.
• Ink is supplied automatically.
5
Press the key several times to
end the setting.
Replacing consumables
Replacing the wiper
The wiper is consumable. When the display indicates the
warning message “Replace a WIPER” it is necessary to
check and replace the wiper, immediately replace the
wiper with a new one.
Also, wipe ink sticking to the lower surface of the slider off.
1
Press
(MENU)
in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press the key.
• “STATION” will be selected.
3
Press to select “WIPER
EXCHANGE”, and press the key.
• If the nozzle cleaning is interrupted, run the head
cleaning without waiting for the configured
cleaning time.
• If you want to continue the nozzle cleaning, please
select [](CONTINUE).
NOZZLE WASH
CANCEL?
CONTINUE<
>CANCEL
• When the warning message for replacing wiper is
shown, confirm whether there is no damage and
fuzz at the top edge of the wiper film. If there is no
damage on the top edge of the wiper film, it is
possible to use the wiper continuously without
replacing it.
• A cleaning wiper is an option.Buy one through the
dealer in your region or at our service office.