1-15
1
2
2
2
5
6
Chapter 1 Before Use
Menu mode
This machine has 4 modes. Each menu mode is described below.
NOT-READY mode
This is the mode in which the media has not been detected yet.
LOCAL mode
Local mode is the mode for the drawing preparation state.
All the keys are effective.
The machine can receive data from the computer.However, it does not perform printing.
This mode permits the following operations:
• Pressing the JOG keys to set up a drawing origin and drawing area.
• Pressing the [ENTER] key to check the remaining amount of ink, the description of the cartridge error, the
model name, the firmware version, and so on.
MENU mode
To set MENU mode, press the [FUNC1] key when this machine is in LOCAL mode.
In this mode, each function can be set.
REMOTE mode
This machine prints the data it receives.
REMOTEMENU
POST1 POST2
TEST PRINT
CLEANING
FAN
30°/40°30°/50° HIGH
Local <Setup 1> 12:00
width:1340mm
heigth: 4.0mm
Displays the current heater
temperature.
The color of the icon above the
temperature display changes
with the current heater status.
Orange : Temperature rising
Green : Set temperature
reached
Glay : Heater off
Displays the current head
height and the detected media
width.
Displays detected ink levels
(approximate)
Displays the functions that
have been set for the function
keys [FUNC1] – [FUNC3].
[SEL] key
Function key [FUNC1] ~ [FUNC3]
Press the [SEL] key to change the functions.
Screen display in Local mode
Displays the time.
Display the current setting number.
To Next Page
Loading...
