MIMAKI TS300P-1800 - Changing the Printing Origin

2-15
2
2
2
5
6
Chapter 2 Basic Operation
4
Push down the clamp lever and then close
the front cover.
• Set the media straight.
5
Press to select "LEAF" .
6
The media detection is started.
(1) The media width is detected.
(2) The media is fed then the rear end of media
is detected.
(3) It returns to the Local when the detection is
completed.
Notes when using media press
Changing the printing origin
The position of the printing origin can be changed.
Moving the LED pointer to the changing position and
deciding the position.
1
In Local, Press .
• It enters into the origin setting mode.
2
Press to set a light
point of the LED pointer to thechanging
position.
• Select the carriage and media, moving the point
with [][][][].
3
After determining the origin, press the
key.
• The printing origin is changed.
Typical setting position of printing
origin
The printing origin in the depth direction (X') is positioned
at about 75 mm rearward from the slot for cutting on the
platen. The printing origin in the scanning direction (Y') is
positioned at 15 mm from the right end of the media. The
value in the scanning direction (Y') can be changed using
[MARGIN] in FUNCTION mode. ( P.3-8)
This can be changed by using the Jog key.
• Set the media on the black part of the platen so
that it comes out approximately 40mm. If it is
shorter than that, it may not be able to perform the
media detection.
• When installing the media, align the media’s right
edge with the groove in the platen. Placing the
media rightward of the groove will make it rise up if
it moves obliquely, and this could cause damage
to the head.
• If a media is misaligned to the right/left more than
fixed position, a error message “MEDIA SET
POSITION R” or is displayed. Set the media
again.
Media
Approximately
40mm
Media
Groove
Media
Press
X
0.0
Y
0.0
POST1 POST2 FAN
SET ORIGIN
30°/40°30°/35°40°/50°
slot for cutting
approx. 75 mm(X’)
15 mm
(Y’)