MIMAKI TS300P-1800 - Setting of Vacuumfan; Setting of Feed Speed; Setting of Feed Quality

3-9
1
2
3
4
5
6
Chapter 3 Setup
Setting of VacuumFan
Sets the absorbability of the media.
By setting the absorption power to match the media, you
can prevent print errors due to media rise-up.
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press
(>>)
.
4
Press to select “VACUUM FAN”,
and press the key.
5
Press to select a set value, and
press the key.
• Set value : HOST/WEAK /STANDARD/ STRONG
6
press the key several times to
end the setting.
Setting of Feed Speed
Changes the media feeding speed in printing.
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press
(>>)
twice.
4
Press to select ““FEED SPEED”,
and press the key.
5
Press to select a set value, and
press the key.
• Set value : HOST / 10 to 200%
6
Press the key several times to
end the setting.
Setting of Feed Quality
Change the speed and acceleration to feed a media
during printing. If the media feed is not stable, change the
setting into [QUALITY] may improve the situation.
Action will be changed as follows according to a setting.
• STANDARD : The media feed is done with the default value
of the speed and acceleration.
• QUALITY : The media feed is done with the speed and
acceleration slower than the default setting
value.
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press
(>>)
twice.
4
Press to select “FEED
QUALITY”, and press the key.
5
Press to select a set value, and
press the key.
• Set value : HOST / STANDARD / QUALITY
6
press the key several times to
end the setting.
• Some speed is not changed according to a setting
condition.
• The media feed speed during printing is decided
by this setting and the set value in [Setting of Feed
Quality].
• The media feed speed during printing is decided
by this setting and the set value in [Setting of Feed
Speed].