MIMAKI TS300P-1800 - Replacing the Cutter Blade

4-19
1
2
2
4
5
6
Chapter 4 Maintenance
Replacing the Cutter Blade
The cutter blade is consumable.When the cutter blade
gets dull, replace it with a new one (SPA-0107).
1
Press
(MENU)
in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press the key twice, and open the
front cover.
• The carriage moves onto the platen.
3
Replace the cutter unit by the carriage.
(1) Loosen the screw of the cutter unit.
(2) Remove the cutter unit.
(3) Mount a new cutter unit.
(4) Fasten the screw of the cutter unit to secure
the cutter unit.
4
Close the FRONT cover.
5
Press the key.
• The blade is sharp.Be careful not to hurt yourself
or anyone else.
• Store the cutter blade in a place that is out of the
reach of children.In addition, dispose of used
cutter blades according to regional laws and
regulations.
• When replacing the cutter blade, it is
recommended to place a sheet of paper under the
cutter blade. This will help pick up the cutter blade
if it drops.
Carriage
Screw
Cutter unit