4-18
Chapter 4 Maintenance
Replace the waste ink tank with another
When the waste ink tank becomes full, carry out the
procedure below to replace the waste ink tank, and in the
Maintenance menu, set 0% for waste ink tank information.
If you replace the waste ink tank before the waste ink tank
confirmation message is displayed (before the 2L tank is
80% (1.6L) full), carry out the same procedure to replace
the waste ink tank.
1
Press
(MENU)
in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press to select “INK TANK
EXGHANGE”, and press the key.
• Waste ink tank information is displayed.
3
Press to adjust the level, and
press the key.
4
Press the key.
• The waste ink tank amount that is managed in this
machine will be reset.
5
Pull the waste ink tank stopper to open to
the front.
6
Pull it frontward to remove by holding the
waste ink tank handle.
7
Replace the waste ink tank.
(1) Prepare a new waste ink tank (SPC-0117).
(2) Insert the waste ink tank by holding a handle
of the tank.
8
Close the waste ink tank stopper.
9
Press the key.
• The ink discharging amount that is controlled by
the machine is reset and the message is
cancelled.
• Put a cap on the waste
ink tank removed.
• Waste ink is equivalent to waste oil of industrial
waste. Request an industrial waste disposal
company for disposal of waste ink.
To Next Page
Loading...
