Chapter 2 Basic Operation
2-14
When you want to change the take-up
method to the method using the
tension bar during printing
While printing using only the take-up device, you can
change the take-up method to the method using the
tension bar.
1
Press while
printing.
• Winding operation stops.
• When the media is set inward, the media is fed to
the position where the tension bar can be set.
(The countdown for the feeding amount is
displayed.)
2
Lift the tension- bar down slowly.
• Unlock the tension-bar, and then lift it down.
• When the media is set inward, wait until the count
becomes "0", and then lower the tension bar.
3
Control to switch to the winding method
using the tension bar.
(1) Detect the tension bar origin.
• When the switching operation fails, the result
is displayed, and then winding operation
using the take-up device continues. Return
the tension bar to the locking position.
Setting leaf media
Unlike roll media, leaf media does not need to be retained
with the roll holders.
1
Open the front cover, and then raise the
clamp lever.
2
Insert the leaf media between the platen
and the pinch rollers, and push down the
clamp lever.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
3
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
In this case, set the machine setup of “Setting the
Media Detection” to “MANUAL” ( P.3-17), and
refer to P.2-9 “Setting of the manual media width
setting” and set the media width.
To Next Page
Loading...
