MIMAKI TS300P-1800 - Setting Pre-Feed

3-12
Chapter 3 Setup
Setting Pre-feed
The following effects can be expected by feeding back
and forth the media before printing.
• Prevent media from sticking to the various rollers and the
platen of this machine.
• If the wrinkle is shifted to the media, wrinkle reduction can be
expected.
1
Press
(MENU)
in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press
(>>)
twice.
4
Press to select “Pre-Feed”, and
press the key.
5
Press to set the feeding media
lengths.
• Set Value : OFF, 100 to 500mm
• When [OFF] is set, pre-feed is not executed.
6
Press the key.
7
Press the key several times to
end the setting.