AC inlet
Connect the power cable to the AC inlet.
Clamp lever (rear)
Interlocks with the clamp lever in
the font of this machine.
Main power switch
Turns on/off the main power for this machine. Leave
the main power turned on to prevent ink clogging.
Roll guide stay
Auxiliary stay that prevents the media from bending
when roll media is set.
Vent filter box
Vents the ink mist that
occurs during printing.
Roll holders
Putting this into the paper core
(right and left) of a roll media, hold
the media. It supports the paper
core of 2 inch and 3 inch.
LAN connector
This is Ethernet interface connector.
Top blower
Suppress upward
floating of the ink mist
that occurs during
printing.
USB 2.0 connector
This is USB2.0 interface connector.
To Next Page
Loading...
