MIMAKI TS300P-1800 - Setting a AUTO Power-Off; Setting Take-Up Unit; Setting Top Blower

Chapter 3 Mchine setting
3-16
Setting a AUTO Power-off
When no operation has been performed for the set time,
the power supply is automatically turned “OFF”.
1
Press
(MENU) (twice)
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “AUTO POWER
OFF”, and press the key.
3
Press to select a set value, and
press the key.
• Set Value : none, 10 to 600min
4
Press the key several times to
end the setting.
Setting Take-up unit
For the “TAKE-UP UNIT” settings, set the following items:
• Use take-up unit/ Do not use take-up unit.
• Use/Do not use the take-up tension bar.
• Operation when the ON/OFF switch for take-up unit is
pressed.
1
Press
(MENU) (twice)
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “TAKE-UP UNIT”,
and press the key.
3
Press the key.
• “TAKE-UP UNIT” will be selected.
4
Press to select a set value, and
press the key.
• Set Value : ON/ OFF
5
Press , and press the key.
• “TAKE-UP TENSION BAR” will be selected.
6
Press to select a set value, and
press the key.
• Set Value : ON/ OFF
7
Press , and press the key.
• “TAKE-UP SW” will be selected.
8
Press to select a set value, and
press the key.
• Set Value : Continuance/ Temporary
Continuance :
Switching ON / OFF the winding operation when
pressing the switch each time. (Take-up unit in
operation does not stop until press again ON /
OFF switch.)
Temporary :
Do the winding operation only while holding
down the switch. (When release the switch,
winding operation is stopped. )
9
Press the key several times to
end the setting.
Setting Top Blower
Set the operation of the top blower in print.
Turn the top blower setting “ON”, and you can set the
strength for the blower.
1
Press
(MENU) (twice)
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “Top blower”,
and press the key.
3
Press to select “ON”, and press
the key.
ON : You can choose the air volume of the blower.
OFF : The top blower does not work while printing
process. Proceed to step 6.
4
Press to select “STRENGTH”,
and press the key.
5
Press to select a set value
(AUTO/ STRONG/ WEAK), and press the
key.
• Set value : ON/ OFF
6
Press the key several times to
end the setting.
• If you are using a direct-connection unit, even set
to “Continuance”, it will automatically run the
“Temporary” operation.