MIMAKI TS300P-1800 - Connecting the Power Cable

Chapter 1 Before Use
1-10
If the PC or device connected to the printer is not
1000BASE-T, you cannot perform printing.
After connecting, check the following.
(1) Check the printer screen display.
• On the local screen or the media detection screen, press
the [Enter] key several times to display the information
screen.
• Check that "1000Mbps" is displayed for the LAN status
item.
(2) Check the green light of the LAN connector.
• After turning on the machine, the lamp for the LAN
connector will light up as follows.
Connecting the power cable
1
Insert the power cable into an inlet of the
machine.
2
Secure a cable band.
• Secure the cable with the cable band attached to
this machine.
3
Insert the power plug into a plug socket.
• If "100Mbps", "10Mbps", or "No connect" is
displayed, you cannot print using the LAN.
• If "100Mbps" or "10Mbps" is displayed, you can
use event mail ( Chapter3 “ Setting event
mail function”).
Color State Condition
Green
Lighting Connected with 1000BASE-T
OFF Connected without 1000BASE-T
Yellow
Lighting Link-up
Blinking Receiving data
OFF Link-down
• If the yellow light only lights up, or is blinking, the
status is not 1000Mbps. Check the specifications
of the PC, device, and cables.
Switching hub
 If connecting via a switching hub
INFORMATION
LAN Status 1000Mbps
• Do not use any power cables other than the
attached power cable.
• Be sure to connect the power cable to the outlet
near this machine, and make sure that the power
cable can be easily removed.
• Connect the power cable to the grounded
outlet.Otherwise, it may result in fire or an electric
shock.
Inlet
Power cable
Cable band
Power plug
Socket