MIMAKI TS300P-1800 - Powering On and Off; Image Quality and Nozzle Issues; Ink Specifications

ii
Setting a roll media............................................................................ 2-5
Using the tension bar to set the roll media ........................................ 2-8
Take-up device................................................................................ 2-10
Setting leaf media............................................................................ 2-14
Changing the printing origin ............................................................ 2-15
Preparing for the Heaters ............................................................2-16
Changing the Temperature Settings for the Heaters....................... 2-16
Test Printing ...............................................................................2-16
Test Printing .................................................................................... 2-16
Head Cleaning ...........................................................................2-17
About head cleaning........................................................................ 2-17
Perform head cleaning depending on the test printing result .......... 2-17
Setting of Media Correction ........................................................2-18
Setting of Media Correction............................................................ 2-18
If the Positions of Dots Shift... ....................................................2-18
Printing Data ..............................................................................2-19
Starting a Printing Operation ........................................................... 2-19
Stopping a Printing Operation ......................................................... 2-19
Deleting Received Data (Data Clear) .............................................. 2-19
Behavior after printing has been completed.................................... 2-19
Cutting a media ............................................................................... 2-20
Chapter 3
Setup
About SETUP MENU ...................................................................3-2
SETUP MENU table .......................................................................... 3-3
Register the optimal print conditions to match the use...................... 3-4
Setting of Media Correction............................................................... 3-5
If the Positions of Dots Shift... ........................................................... 3-6
Setting the HEATER.......................................................................... 3-6
Setting the Optional heater................................................................ 3-7
Setting of Logical Seek...................................................................... 3-7
Setting of Overprint ........................................................................... 3-8
Setting of Drying Time....................................................................... 3-8
Setting of Left and Right Margins ..................................................... 3-8
Setting of VacuumFan....................................................................... 3-9
Setting of Feed Speed....................................................................... 3-9
Setting of Feed Quality...................................................................... 3-9
Setting of MAPS4 ............................................................................ 3-10
Setting Auto Cleaning...................................................................... 3-11
Setting Interval wiping ..................................................................... 3-11
Setting Pre-feed .............................................................................. 3-12
About MACHINE SETUP MENU ................................................3-13
MACHINE SETUP MENU table ...................................................... 3-14
Setting a AUTO Power-off............................................................... 3-16
Setting Take-up unit ........................................................................ 3-16
Setting Top Blower .......................................................................... 3-16
Setting the Display of Media Residual............................................. 3-17
Setting the PG Drop Adjust ............................................................. 3-17
Setting the Media Detection ............................................................ 3-17
Setting the Drying Feed................................................................... 3-18