MIMAKI TS300P-1800 - Roll Media Handling; Inquiry Sheet

iv
If a Waste Ink Tank Confirmation Message Appears ...................... 4-17
Replace the waste ink tank with another......................................... 4-18
Replacing the Cutter Blade ............................................................. 4-19
Chapter 5
Troubleshooting
Troubleshooting ...........................................................................5-2
Power does not turn on ..................................................................... 5-2
The machine does not start printing .................................................. 5-2
Media get jammed / media is soiled .................................................. 5-2
The heater’s temperature will not rise to the set level ....................... 5-3
Image quality is poor ......................................................................... 5-3
Nozzle is clogged .............................................................................. 5-3
Ink IC warning appears ..................................................................... 5-3
Warning / Error Messages ...........................................................5-4
Warning messages............................................................................ 5-4
Error messages ................................................................................. 5-7
Chapter 6
Appendix
Specifications ...............................................................................6-2
Machine specifications ...................................................................... 6-2
Ink specifications ............................................................................... 6-3
Setting orders depending on ink type ...........................................6-4
Setting orders of ink cartridges.......................................................... 6-4
Sheet for inquiry ...........................................................................6-5