This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow .......................................................2-2
Turning the Power ON/OFF ..........................2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-3
Setting a Media .............................................2-4
Setting the Head Gap .................................. 2-4
Note for media setting ................................. 2-4
Setting a roll media ..................................... 2-5
Setting leaf media ..................................... 2-14
Changing the printing origin ...................... 2-15
Preparing for the Heaters ............................2-16
Changing the Temperature Settings for the
Heaters ...................................................... 2-16
Test Printing ................................................2-16
Test Printing .............................................. 2-17
Head Cleaning ............................................2-17
About head cleaning ..................................2-17
Perform head cleaning depending on the test
printing result .............................................2-17
Setting of Media Correction .........................2-18
Setting of Media Correction ......................2-18
Correct the ink drop position for bidirectional
printing ........................................................2-19
Printing Data ...............................................2-20
Starting a Printing Operation .....................2-20
Stopping a Printing Operation ....................2-20
Deleting Received Data (Data Clear) ........2-20
Behavior after printing has been
completed ..................................................2-20
Cutting a media ..........................................2-21
Chapter 2
Basic Operations
To Next Page
Loading...
