MIMAKI TS500P-3200 - Setting a Roll Media

2-5
2
2
2
2
Setting a roll media
Prepare for the take-up device first
Prepare for the take-up device before setting the roll
media.
1
Fix the tension-bars on the front and the
back of this machine at the tension-bar
lock plate.
• The tension-bar lock plates are on the right front
and the left back of this machine.
(1) Pull the pin on the outside of the tension-bar
lock plate to unlock.
(2) Lift the tension-bars and fix them with the
tension-bar lock plate.
2
Remove the roll shaft on the take-up
device at the front of this machine.
(1) Loosen the cover fixing screw attached to the
cover of left of take-up device and unlock the
AMF lock by sliding it.
(2) Open the covers.
(3) Loosen the cover fixing screw attached to the
cover of right of take-up device and unlock
the AMF lock by sliding it.
(4) Open the covers.
(5) Remove the roll shaft.
• Handle the roll shaft with care, since it is very
heavy with media. To avoid an accident or injury,
be sure to grip the handles on both ends.
• Grip the outside of the tension-bar lock plate of the
tension-bar.
If gripping the other parts, your hand may get
stuck in.
Handle
Pin
Tension-bar
lock plate
Tension-bar
• When remove the AMF lock, the bottom cover will
be lowered.
Cover(left) Cover(right)
Roll shaft
Cover fixing
screw
AMF lock
AMF under cover
Roll shaft