MIMAKI TS500P-3200 - Setting of Overprint; Setting of Drying Time; Setting of Left and Right Margins; Setting of Refresh

3-9
Chapter 3 Setup
3
2
2
Setting of Overprint
Sets the number of layers in which ink is to be applied.
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press to select “Overprint” , and
press the key.
4
Press to set number of Overprint,
and press the key.
• Setting value : Host/ 0 to 9 times
5
Press the key several times to
end the setting.
Setting of Drying Time
In the drying time setting, the each scanning is set.
(during bidirectional printing, the machine stops for a
certain period of time specified for each of the outward
and return scanning.)
1
Press the
(MENU)
key in
LOCAL.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu will be displayed.
3
Press the
(>>)
.
4
Press to select “Drying Time”,
and press the key.
5
Press the key.
6
Press to set drying time, and
press the key.
• Set the drying time for scanning the media.
To enable the drying time specified in your RIP,
select “Host”.
• Setting value : Host or 0.0 sec. to 9.9 sec.
7
Press the key several times to
end the setting.
Setting of Left and Right Margins
Set a non-printing area along the left and right edges of
the media.
The offset value against the standard margin 15mm is set
hereupon.
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press the
(>>)
.
4
Press to select “Margin/L” or
“Margin/R” , and press the key.
5
Press to select a set value, and
press the key.
• Set value : Host/ -10 to 85 mm
6
Press the key several times to
end the setting.
Setting of Refresh
Sets the interval of refresh performed during printing.
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press the
(>>)
.
4
Press to select “Refresh” and
press the key.
5
Press to select a set value, and
press the key.
• Set value : Host/Lv.0 to Lv.3.
6
Press the key several times to
end the setting.
• When you give priority to the setting at the
RasterLink side, make the setting value “Host”.
• “SCAN” set in this machine is displayed as “Pause
Time per Scan” in the RasterLink.
• You cannot specify the print end at the RasterLink
side. When you set this machine to “Host”, printing
will be performed in “PRINT END= 0 sec.” status.
• Pay attention to the settings of the right and left
margins when printing with the media press. If any
of the margins is set to a negative value, printing
may start from a position on the media press.