MIMAKI TS500P-3200 - Setting of Media Correction

3-6
Chapter 3 Setup
5
Press to select the location
selected (SETUP 1 to 4), and press the
key.
• Save confirmation screen will be displayed.
6
Press the key.
• Settings of Temporary will be saved to the location
selected in step 5.
7
Press the key several times to
end the setting.
Reset the registered contents
Reset the contents registered to SETUP 1 to 4.
1
Press the
(MENU)
key in
LOCAL.
2
Press to select SETUP 1 to 4 to
be reset and press the key.
• Setup menu will be displayed.
3
Press the (<<).
4
Press to select “Setup Reset”,
and press the key.
• Confirmation screen of reset settings will be
displayed.
5
Press the key several times to
end the setting.
Setting of Media Correction
Correct the media feed amount to match the type of
media you are using.
If the correction value is not appropriate, stripes may
appear on the printed image, thus resulting in a poor
printing.
A pattern for media correction is printed and a media-
feeding rate is corrected.
1
Set a media. ( P.2-4)
2
Press the
(MENU)
key in
Local.
3
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
4
Press to select “Feed Comp.” ,
and press the key.
5
Press the key to print the
correction pattern.
• Be sure to perform feed correction each time
before printing. The media feed amount may vary,
depending on the remaining amount of the roll
media.
• If use by setting the media to Narrow roll holder,
rewind the roll media by hand and set without
slack. There may not be accurate to correct the
feed amount.
• On completion of [MEDIA COMP.] during use of a
roll media, the media returns to the printing origin.
When a media is set on the narrow roll holder,
slack occurs in the roll media on the backside of
this machine.
Before printing, take up the slack in the roll media
by hand; a loose roll media can result in an inferior
image quality.
• When printing with a take-up device, set the media
first and then perform media correction.
• When printing without using the take-up device,
feed the media until the media reaches the floor
before performing the correction. Otherwise, the
feed amount may not be adjusted normally.
• Two bands are printed in the correction pattern.
• Make adjustment so that an even color density is
obtained in the boundary between the two bands.
Second band
First band
Media advance direction