2-20
Printing Data
Starting a Printing Operation
1
Setting a Media ( P.2-4)
2
Checking the Heater Temperature
3
Press the (REMOTE) key in LOCAL.
• If the heater temperature has not reached the
setting value, the worning message
“TEMPERATURE CONTROL” is displayed.
Even if it has not reached, you can move to
Remote when pressing the [ENTER] key.
• The screen changes to Remote, and data can be
received from the PC.
4
Transmit data to be printed from the PC.
• For the method of data transmission, see the
instruction manual for the output software.
5
Start printing.
• The printing speed may change, depending on
the width of the set media or the position of the
print origin even when the same data is printed.
This is because of a difference in resolution.
Stopping a Printing Operation
Perform the following operation when stopping a printing
operation halfway.
1
Press the
(LOCAL)
during printing.
• The printing operation stops.
• Interrupt data sending at the PC side during the
data is sent from the PC.
• Printing restarts from the interrupted data by
repressing the [REMOTE] key.
Deleting Received Data (Data Clear)
When you want to stop printing, delete the already
received data.
1
Press the key, and press the
(DATA CLEAR)
in LOCAL.
2
Press the key.
• The received data is erased then it returns to the
Local.
Behavior after printing has been
completed
Drying Feed
When printing has been completed, the feeding operation
is performed to dry the printed surface with the drying
heater.
• Perform the feeding operation until the back edge of print-
ing passes the drying heater.
• When you press the [END/POWER] key, the operation is
terminated.
• When the machine has been received next data continu-
ously, it will operate after the last data is received.
• Depending on the position of your drying fan, set the feed-
ing amount. ( P.3-20 “Setting a Drying Feed”)
• When using a roll media, rewind the media by
hand before printing so that it is not loose.When
the roll media has not been rewound tightly, it may
cause the image quality to deteriorate.
• When the same data is printed, the color may
differ if print conditions are changed, including the
resolution, pass, scanning speed, and printing
direction. Check the effects before printing.
REMOTE
540x360 VD
0.0m
4/ B / x1 / W1 / ALL / R
Resolution
Number of passes
The length of
media printed
Scan direction
U :Unidirectional / B : Bidirectional
Scanning speed
x1 : Standard speed/ x2 : Double speed
Data type
VD : Variable data
/
ND : Normal data
Nozzle recovery information
R: Nozzle recovery is performed.
Select head
Waveform selection
W1 : WF1/ W2 : WF2
Screen display during drying feeding
To Next Page
Loading...
