MIMAKI TS500P-3200 - Setting of Refresh Left; Setting of Vacuum Fan; Setting of Feed Speed

3-10
Chapter 3 Setup
Setting of Refresh Left
When you want to make a flushing operation at the left
side of the machine, set to “ON”.
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press the
(>>)
.
4
Press to select “Refresh Left”
and press the key.
5
Press to select a set value, and
press the key.
• Set Value : ON/ OFF
6
Press the key several times to
end the setting.
Setting of Vacuum Fan
Sets the absorbability of the media.
By setting the absorption power to match the media, you
can prevent print errors due to media rise-up.
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press the
(>>) twice
.
4
Press to select “Vacuum Fan”
and press the key.
5
Press to select a set value, and
press the key.
• Set value : Host/Weak /Standard/ Strong/ OFF
6
Press the key several times to
end the setting.
Setting of Feed Speed
Changes the media feeding speed in printing.
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press the
(>>) twice
.
4
Press to select “Feed Speed”
and press the key.
5
Press to select a set value, and
press the key.
• Set value : Host/ 10 to 200%
6
Press the key several times to
end the setting.
• If you change the settings of the print speed, the
color might change. After changing the feed
speed, please check there is no change in the
color in advance.
•
After changing the settings, please perform the
media correction (
P. 3 - 6) .