MIMAKI TS500P-3200 - Setting of MAPS4

3-11
Chapter 3 Setup
3
2
2
Setting of MAPS4
If performing media correction does not resolve feeding
stripes, use the MAPS (Mimaki Advanced PassSystem)
function to disperse the pass boundary to make the
feeding stripes less visible.
Setting MAPS4 Function
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press the
(>>) twice
.
4
Press to select “MAPS4” and
press the key.
5
Press to select a set value, and
press the key.
• Set value：Auto/ Manual
• If you have selected “Manual”, proceed to step 5.
Otherwise, proceed to step 10.
6
Press to select the "Speed”, and
press the key.
7
Press to select the speed, and
press the key.
• Set value：50 to 100%
8
Press to select the "Smoothing
Lv.”, and press the key.
9
Press to change the smoothing
level, and press the key.
• Set Value : 0 to 100% (set in units of 5%)
• The MAPS4 effect become strong as the set value
increase, and become weak as the set value decrease.
10
Press the key several times to
end the setting.
• Changing the MAPS4 settings may change the
color tone. Check the effects before use.
• MAPS may not be effective depending on image to
be printed. Use it after checking effect in advance.
 Conditions which the effect of the MAPS
function is not obtained
The MAPS function may be disabled under the follow-
ing conditions. In addition, the MAPS is not effective,
depending on the image to be printed.
4-colors ink set
Resolution Pass Scan speed MAPS MODE
360 x 360HQ 2 pass Normal speed
Manual
(Speed: 100%)
540 x 360 2 pass High speed
540 x 720 4 pass High speed
720 x 720 4 pass High speed
720 x 1080 6 pass High speed
6-colors ink set
Resolution Pass Scan speed MAPS MODE
540 x 360 4 pass High speed
Manual
(Speed: 100%)
540 x 540 6 pass High speed
720 x 720 8 pass High speed
720 x 1080 12 pass High speed